The scope of use of steam boilers is very wide, so it is also one of the more frequently used ones on the market. However, in the daily operation of the steam boiler, certain problems and losses may occur because the quality of the boiler itself is not good enough, or the furnace operator does not operate properly. Zhengzhou Fangkuai Boiler Factory is here to talk about how to solve some common problems in the operation and use of steam boilers.
During the operation of a steam boiler, three common problems are mainly: the exhaust speed cannot meet the requirements, low-temperature corrosion, and damage to the steam and water supply pipes. The common problems of low-temperature corrosion are chemical and electrochemical corrosion. The above two kinds of corrosion occur on the wall whose temperature is lower than the acid dew point. If the dust on the heating area is not cleaned in time, the corrosion rate will be accelerated.
For steam boilers, in addition to corrosion, the common reasons for slow exhaust speed are as follows:
The filter element of the exhaust outlet is blocked and the inlet filter is blocked. The solution is to replace the filter element, change to a larger pipeline, or shorten the pipeline distance in design. Clean the filter and install a filter.
Another point is that the steam pipe and water supply pipe of the steam boiler system are damaged and make noise. Deal with this situation in time, and the solution is as follows: if the water supply pipeline is slightly leaked, it will not affect the normal water supply of the boiler or cause the expansion of the fault. It can maintain the operating state in a short time, adjust and use the standby boiler as soon as possible, and do not continue to use it. To avoid intensified failures and threats to personal and equipment safety, boiler operators should contact boiler system maintenance personnel in a timely manner to perform maintenance work on steam boilers.
In addition to the boiler itself, there are other problems in the boiler system, such as centrifugal pumps, burners, condensers and other system components.
